AP_PERIPH CAN NODE RM3100

Matek AP_PERIPH CAN RM3100 Kompass für Ardupilot AP Periph - CAN-L4-3100 - Übersichtsseite

Link zum Premium-Modellbau Shop

CAN Node mit RM3100 Kompass

Weitere Informationen finden Sie auch hier:

CAN-L4-3100 is a professional grade CAN Magnetometer based on RM3100 & ArudPilot AP_Periph firmware.
RM3100 sensor technology provides high resolution, low power consumption, large signal noise immunity, a large dynamic range, and high sampling rates. Measurements are stable over temperature and inherently free from offset drift.

PNI RM3100 Geomagnetic Sensor
CAN node MCU: STM32L431xC, 256KB Flash
Interface
- CAN, DroneCAN Protocol
- UART2, MSP output (MatekL431-Periph fw)
- UART3, for external GNSS module
- ST debug, SWCLK & SWDIO
LED
- Blue, Fast blinking, Booting
- Blue, Slow blinking, working
- Red, 3.3V indicator
Power supply for CAN-L4-3100 board : 4.5~5.5V @5V pad/pin
Power consumption: 22mA
Operating Temperatures: -40~85 °C
Physical
- Board Size: 36mm*25mm*10mm. 6g
- 3D File CAN-L4-3100_step.zip
Firmware
- ArduPilot AP_Periph: MatekL431-GPS or MatekL431-Periph
- Update via DroneCAN GUI Tool or Mission Planner (AP_Periph.bin)
- Update via STLink (AP_Periph_with_bl.hex)
Parameters
- CAN_P1_DRIVER = 1 if attached to CAN bus1 port or CAN_P2_DRIVER = 1 if attached to CAN bus2 port
- COMPASS_AUTODEC = 1

CAN-L4-3100 is pre-installed with “MatekL431-GPS” firmware.
MSP feature is disabled in “MatekL431-GPS”. If you want to use MSP feature, reflash it with “MatekL431-Periph” firmware(AP_Periph_with_bl.hex) over SWC/SWD pads via ST-LINK.
Put magnetometer far from power lines/ESC/motors/iron based material. >=10cm
2 ears for mounting can be cut off if you don’t need it.
If the CAN wires are too long, bridge the “120R” jumper.

Last updated 10 months ago