ADS-B IN Carrier Board

Cube ADS-B Carrier Board - Trägermodul für The Cube (Pixhawk 2.1) - Übersichtsseite

Beschreibung

Es handelt sich um die neue Version des Boards mit integriertem ADS-B Receiver von UAvionix. (Diese Version wird auch im Cube Orange Bundle ausgeliefert). Ideal auch um z.B. ältere Cubes nachzurüsten.

Das Board ist dafür vorgesehen alle Schnittstellen des Cube zur Verfügung zu stellen. Die Sensoren und die Rechenleistung hingegen sind im Cube untergebracht.

Zum Betrieb ist somit zwingend ein Cube notwendig.

Das Board verfügt über den Standard DF17 Stecker und kann mit allen Cubes (Blau, Lila, Schwarz, Orange, Gelb) eingesetzt werden.

Wir bieten Bundles (Cube mit Carrier Board sowie Cube mit GPS und Carrier Board) separat an.

Lieferumfang:

- 1x ADS-B Carrier Board

Ein Cube ist nicht im Lieferumfang enthalten.

Technische Daten und Integration:

This is an updated version of the original carrier board, its overall footprint is identical to the previous versions and main changes compared to original carrier are as follows:

  • Integration of uAvionix ADS-B IN Receiver

  • Removal of Intel Edison Bay and Debug USB Ports

  • Correct labelling Of CAN Ports

All other specification and external connections remain identical to the original board apart from the following

The new carrier board has an integrated 1090Mhz ADS-B IN receiver from uAvionix, this allows users to detect ADS-B OUT equip aircraft in the area and displays information such as the Position, Altitude, Speed and ID of the detected aircraft on a connected ground station. This also allow sense and avoid features included in Ardupilot to be used if configured.

This ADS-B receiver is connected to the internal serial 5 Port, this is compatible with Ardupilot, Mission Planner and QGC.This system will

To enable ADSB in Ardupilot to detect aircraft on ground station you need to be using Copter or Plane 4.0 onward for the Cube Orange and set the following parameters

  • ADSB_ENABLE = 1 Enable ADS-B (Disabled as default)

  • SERIAL5_BAUD = 57 Set baud rate

  • SERIAL5_PROTOCOL = 1 Set protocol

  • SR0_ADSB = 2 Set ADSB stream rate to ground station

Note: You may need to set SR1_ADSB = 2 to enable receiving on ground station on Telem 1 or SR2 for Telem 2.

For Advanced users you can set the ADS-B Alarm and Sens and Avoid with the following parameters

  • AVD_ENABLE = 1 Enable alarm and avoidance using ADSB

  • AVD_W_ACTION = 1 (0=Disable, 1=Enable ) Enable Warnings

  • AVD_F_ACTION = 1 Controls how the vehicle should respond to a projected near-miss (i.e. 0= None, 1= Report, 2=Climb Or Descend, 3=Move Horizontally, 4=Move Perpendicularly in 3D, 5=RTL or 6=Hover)

  • AVD_F_RCVRY = 3 sets how the vehicle will behave after the vehicle has cleared the near-miss area (i.e. 0 = Remain in EXCER_ADSB, 1 = resume previous flight mode, 2 = RTL, 3 = Resume if AUTO else Loiter)

Last updated